Firearm Forums - Arms Locker banner

22 impact on front end washer, PVC silencer

4454 Views 16 Replies 10 Participants Last post by  Hardballer45
will crack off the end of the PVC, where you have cut the groove for the internal snap ring. Neither the PVC pipe nor the epoxy, nor the pins (sideways thru rear of PVC, and into sides of bolt head) have any "give' in them, the way a welded in, threaded adapter has in a steel .22 can-tube. If you dont get everything made straight with the bore, there's no tapping it with a mallet,in order to get it straight. You have to start all over.
1 - 1 of 17 Posts
Just be sure of the legal ramifications should you decide to build one of his silencers.

There are far better designs out there.

You'd be better off buying one from an established manufacturer.

1 - 1 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.