Arms Locker banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Phase 1: Beginner’s Gunsmithing Quiz!
I am semi-retired and I am taking a self-passed and self-taught Beginner’s Gunsmithing course. I have answered all of questions but during my study and research I am having some problems related to the following quiz questions. Either I am not sure of the correct answer or I have conflicting answers.

Can you help me determine the correct answers for these few quiz questions? Please correct my wrong answers!

Thanks for your help.

7. When using the collimator, remember to: b
a) use a loose fitting spud
b) keep the collimator from touching the end of the barrel
c) push the collimator in until it is tight against the crown
d) point the collimator at the sun for accurate results

8. Spring on the collimator spud can be positioned up or down in relation to the barrel. True or False true

9. When adjusting dovetailed iron sights remember that the: a
a) front sight moves opposite of the point of impact
b) front sight moves the same direction as the point of impact
c) front sight cannot adjust for windage
d) rear sight adjusts for windage only

23. A properly installed sling swivel should be: c
a) perpendicular to the bottom line of the stock and 3" from each end of the wood (except when there's checkering)
b) parallel to the top line of the stock and 3" from each end
c) perpendicular to the top line of the stock and 3" from each end of the wood (except when there's checkering)
d) parallel to the bottom line of the stock and 3" from each end

32. When selecting or building a work bench the two most important factors to consider are: c
a) width and height
b) height and length
c) strength and height
d) thickness and length

37. When you are wiping the excess oil off your parts during a clean and oil, it is a good time to: b
a) test fit them in the receiver
b) inspect them for wears or breakage
c) polish them for extra measure
d) rinse them again if they are not clean

39. When installing a red ramp the ends of the ramp slot must be: c
a) wider at the top than the bottom to keep the ramp in place
b) square to the top of the ramp
c) narrower at the top than the bottom to keep the ramp in place
d) rounded at the top

40. When collimating a scope, the windage, and elevation adjustments: a
a) should be near the center of their range when finished
b) do not have to be centered
c) should loc-tited in place when finished
d) can be left where they are
 
1 - 1 of 1 Posts
Top