Firearm Forums - Arms Locker banner
1 - 1 of 1 Posts

· Banned
9,121 Posts
Discussion Starter · #1 ·
on rear of barrel for it, weld up and slot the slide, etc, THEN you drill the hole for the pivot pin, in the slide and in the extractor, do final testfiring, and then you harden the extractor. Get this out of sequence, and you will probably never get the extractor to work properly.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.