Firearm Forums - Arms Locker banner
1 - 1 of 1 Posts

· Banned
9,121 Posts
Discussion Starter · #1 ·
the solid tin swc's, while hollowpointing and hollowbasing them in the lathe Slit about half way down their length, 2 in 9mm, 2 in .45, one for each end, you see. Tightening the chuck clamps the soft, rounded-edged aluminum on the bullet, thereby holding it without marking or damaging it.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.