Firearm Forums - Arms Locker banner

1 - 6 of 6 Posts

·
Registered
Joined
·
9,117 Posts
Discussion Starter · #1 ·
4" Sport Model. 6" Match target, which somebody had shortened to a 3" barrel. It had the 1911 style mag release. And an original version of the gun, much smaller grip-frame, which somebody had shortened to 3" also. That made it less than 7" long, and it was acceptably accurate, but all 3 had trigger pulls that basically sucked, compare to a High Standard's,anyway.
 

·
Registered
Joined
·
10,279 Posts
Woodsman trigger gotcha stumped, huh? A good gunsmith can improve almost any trigger but you ain't a good gunsmith. The trigger on my Woodsman is excellent so I haven't touched it.

RIKA
 

·
Registered
Joined
·
9,117 Posts
Discussion Starter · #3 ·
that was 30 years ago, dummy.

I wouldn't bother to own a woodsman, so why bother with studying the lockwork, hmm? The M21's trigger is FAR superior, and the gun is adequately accurate, and ENOUGH smaller and lighter to open REALMS that the Woodsman can't touch. The 2214 smith has a much better trigger, and is also pocketable. The Woodsman is a bulky, heavy clunker by comparison. The only work a M21's trigger needs is some means of correcting the overtravel, but so does the Woodsman. Same technique works on either one. Remove trigger, clamp its tip in a vise, heat the curve dull red with the torch, tap the upper part of trigger with a mallet, bending it, increasing the acuteness of the radius.
 

·
Registered
Joined
·
10,279 Posts
Seems like a lot of trouble when you could drill and tap one hole and install a trigger stop screw.

RIKA
 

·
Registered
Joined
·
5,890 Posts
Raider said:
Seems like a lot of trouble when you could drill and tap one hole and install a trigger stop screw.

RIKA
LOL

Where's that whip smiley when we need it?
 

·
Registered
Joined
·
4,648 Posts
Raider said:
Seems like a lot of trouble when you could drill and tap one hole and install a trigger stop screw.

RIKA
:beer:

and the next forrest fire in CO. is just gk going down in flames, again.....
 
1 - 6 of 6 Posts
Top